Be sure you know which one is the SD card. It might not necessarily be the last one in the list. The SD card will be the one that just showed up. Make a note of the size of the disks listed, and then insert the SD card and run it again. If you are unsure, close DiskPart and remove your SD card, then load it back up and run “ list disk” again. In the above example I can see that Disk 0 and Disk 1 are the disks in my PC, as the sizes relate to the size of my C: and D: drives.ĭisk 5 is my SD card, as it is roughly the size of the 16GB card in my card reader. If you select the wrong disk, you might damage your OS and have to reinstall or repair it. You need to identify which of the listed disks is your SD card. This is the only step in this guide where you need to be a little bit careful. SELECTING THE CORRECT SD CARD IN DISKPART Start by typing “ list disk” and taking a look at the output. You will then be presented with the DiskPart utility screen, which is the command line interface we will use to format the SD card. If you’ve ever inserted an SD card from an Anbernic device into a Windows PC, you’ll likely be familiar with this error message. If necessary, assign a drive letter by typing “ assign“.Format the SD card by typing “ format fs=fat32 quick“.Create a new partition by typing “ create partition primary“.Select the SD card using “ select disk #” where # is the number of your SD card.List the connected disks by typing “ list disk“.It’ll be ready to flash whatever OS you want to it, or use for any other purpose. At the end of this guide you’ll have a fully functional SD card that Windows can read. You will need to use the command line, but it’s nothing to be afraid of. DiskPart is built in to Windows and can do this for you. Actually though it’s not necessary to install anything. I often see people recommending third party programs to reclaim and reformat those partitions in Windows. In this guide we’ll have a look at how to format an SD card with Linux partitions in Windows using DiskPart. This means that when you insert the card into your PC it shows as two or 3 different drives. The Linux based operating systems such as EmuELEC, Batocera, ArkOS, Retro Arena, 351 ELEC etc all create partitions on your SD card when flashed. If you’re wanting to completely wipe your microSD card so that you can flash a new OS to it, it’s not quite as easy as inserting the card into your Windows PC and formatting it.
0 Comments
Leave a Reply. |